X3e

It can be for two reasons:

1. Due to dirt: A simple maintenance cleaning will solve it.

2. Due to valve core loosening: Pressurize it and put the product underwater to locate the leak.

It may be due to:

1. Suction effect: Get help from another person or apply hot water to the threaded area. Prevent it by always closing the container one thread less than the limit.

2. Due to dirt: Prevent with simple maintenance cleaning.

There is no set time, it depends on use, but every 10-12 uses would be recommended. If you perform continuous cleaning of the product it will be less necessary.

It depends on many factors, but we guarantee an increase in ball lifespan of up to 3 times their usual performance.

The problem comes from a previous poor condition of the balls. Manufacturers sometimes sell balls in the same can with different pressure levels. Our product reveals the pressure difference between them, and sometimes causes the low-pressure ball to yield or sink.

All our tubes come with a cap manufactured by us, whose head helps press the valve and release the air.

Between 5º and 24º degrees. The two factors that harm the product are inactivity and cold. It is important to keep the pressurizer warm in winter.

The pump is placed (with the lever down) by pushing down to cover the golden valve head. Once inside (and not before), lift the lever to secure the pump. You can now pressurize your tube.

Aluminum, 360º rotating gauge and T-shaped grip handle. The pump has an interchangeable nozzle to use both types of valves that exist (presta and schrader).